The CMDFlash Full Slave tuning tool is a reader/ programmer tool, supporting; BDM, EOBD K-LINE, EOBD CAN-BUS and EOBD PWM for all new generation ECUs. With BDM you need to unplug the ECU from the vehicle, open and connect it to the Flash tool using a connector available on every Bosch EDC16, Marelli, Siemens and Delphi ECU.

This tool can be sold as a plug-in of our Map3d software or as stand-alone tool. The software allows you to read/ write the EPROM (29bl802/ M58), the internal firmware and the serial e2prom containing the vehicles' codes. Checksum correction algorithm is automatic for all the ECU families, this mean you do not have to care about checksums calculations.

With this tool it is possible to read all the ECU's EPROM, and after a bad map tuning, a system hung, or an interrupted write operation, it is always possible to restart the program operation to restore the ECU and start the vehicle. All the ECU data can be stored in a single file with additional info like brand, model, plague, chassis number, data, note, customer, etc. With search facilities and information directly integrated in Microsoft Windows Explorer.

CMDFlash Full Slave includes: 

• OBD KLine, CANBUS, DoiP ENET,
• VAG FRF/ ODX/ SGO Flasher,
• BOOT/ Bench interface for all supported processors: ST10, C167, Renesas, TriCore, TC29x, v MPC5777, and BDM - MPC5xx,
• Read and write encrypted files only,
• All accessories included for OBD, BOOT and Bench,
• High current power supply suitable for BOOT, Bench and BDM,
• SGW adapter FCA group,
• One year free subscription (value > € 1100).

*MPC55xx BDM, positioning frames with adapters and Industrial Vehicles package are not included

Free DCF Credits!
Tuning-shop.com gives away 10 DCF tuning file credits when ordering a Slave tool which is linked to the Master tool of Dyno-ChiptuningFiles.com. These 10 Free credits are only available if the slave is linked to the Master tool of Dyno-ChiptuningFiles for at least one year. The Slave user must have purchased a minimum of 10 Slave Credits from dyno-chiptuning-files.com during the year.

Transfer
Slave transfer incurs cost and requires an approval from the current Master, possibly a mandatory update of the subscription (if the subscription is not active any more). The Slave user must have purchased a minimum of 10 Slave Credits from dyno-chiptuning-files.com before a transfer.

Subscriptions
This tool utilizes an annual subscription to provide updates and automatic functionality. When purchasing this tool, one year of activation is included. Afterwards, the annual fee depends on the version: Master or Slave. The prices can be found on the subscription page of this tool.

More CMD Flashtec 

CMD11.00.05