This new CMDFlash extension allows you to tune IROM and XROM of the new Bosch EDC17 and MED17 ECU's with locked TriCore microprocessors. The product is based on a new additional interface to be connected to the CMDFlash unit. This new interface is developed in order to provide its user the same friendly operative mode as BDM.

For all the EDC17 ECUs with the Bosch pads on board (such as the old EDC16 BDM) you just need the new provided EDC17 probe positioning frame, no more extra-wiring will be required on the front ECU connectors. For some ECUs soldering of boot resistors is required.

Just press ID, read or write and the CMDflash interface will do everything automatically, exactly like the old BDM.

We provide cables for ECU's such as Mercedes EDC17 too (with the pads placed on the other side of the pcb) you do not need to extract the pcb from the case. Power is supplied through the CMDFlash interface, no additional table power supply is required. Do not use 3rd part checksums, full RSA checksum corrections for all cars is included in this plug-in.

Many ECU's have IROM or XROM or IROM+XROM configuration. The CMDFlash software automatically reads all ECU content, and saves it for backup in a special folder. In the meantime, it extracts only the calibration data, allowing the user to save, and tune it, so one does not have to search for calibration data in IROM and/ or XROM. CMDFlash will do it for you! The same for writing!

More CMD Flashtec

CMD11.01.02