OBD Solutions for PSA BOSCH EDC17C60

Released new FLEX software for OBD programming/tuning of engine control unit PSA BOSCH EDC17C60, this is installed on brands like Citroën, Peugeot, Opel, DS, Toyota, just to mention some of them.

With this FLEX update (5.21.0.0) chiptuning is now possible, the new OBD Full protocol allows to read & write content of the internal Flash memory. This solution was also developed to give access to the EEPROM, facilitating full calibration of the entire memory.   

Supported vehicles:

• Citroën Berlingo 1.6 BlueHDI (2018)
• DS 4 1.6 BlueHDI (2017)
• Opel Crossland X 1.6 BlueHDI (2018)
• Peugeot 308 1.6 BlueHDI (2018)
• Toyota Proace 1.6 BlueHDI (2015)

The new protocol PSA BOSCH EDC17C60 OBD is available for the following software packs:

• FLS0.1 – SW Flex ECU (cars, vans, bikes) OBD + Bench
• FLS0.5 – Package Flex FULL

Time to Read: ~ 3 minutes | Time to Write: ~ 1.40 minutes

New Protocols Added:

(OBD)

• ECU – TOYOTA BOSCH EDC17C60 Read/Write/Checksum Internal Flash ; Read/Write/Checksum Internal Eeprom ; Full Backup
• ECU – PEUGEOT BOSCH EDC17C60 Read/Write/Checksum Internal Flash ; Read/Write/Checksum Internal Eeprom ; Full Backup
• ECU – OPEL BOSCH EDC17C60 Read/Write/Checksum Internal Flash ; Read/Write/Checksum Internal Eeprom ; Full Backup
• ECU – DS BOSCH EDC17C60 Read/Write/Checksum Internal Flash ; Read/Write/Checksum Internal Eeprom ; Full Backup
• ECU – CITROEN BOSCH EDC17C60 Read/Write/Checksum Internal Flash ; Read/Write/Checksum Internal Eeprom; Full Backup

Take a look at the protocols newly added to the Flex vehicle list.